How to Apply Longboard Grip Tape
The things that are required to apply grip tape to your longboard include: Skateboard Deck, Skateboard Grip tape, File, accompanied by a Razor Blade or Box Cutter. The following are the ways on applying grip tape suitably: sector 9 longboards skateboards • Detach the paper on the grip tape. This will expose the sticky surface. •You need to use the piece of the backing paper to hold the surface of the tape to protect your hands from the sticky area. •Slice the grip tape slightly greater than the board by deciding its midpoint. Allow the grip tape to hang down a little in the central point. This is to make sure that the grip tape on the middle of the board would stick. Once the tape has stuck on the middle, you need to make sure that you meticulously stick on the edges and this has to be carried out from the middle onwards. Because this is really sticky, remember that you have to handle this very carefully. loaded decks •To be able to scratch the outer place of your deck in the longboard, you need to use a metal file or even the metal community of your screwdriver. Make sure that you firmly rub these constantly until you have removed all the grains. Additionally you will need to be sure that you can see a white line visible which ought to be witnessed likewise inside the grip tape to benefit finding out the board’s limits. •Using a cutter or razor blade, you position this 45 degree and cut upward to remove excess grip tape. You need to do this starting at the nose or the tail. After you’ve achieved this, move along the white outline and go the blade alongside the sides to cut supplemental grip tapes. check here •In order to level the uneven edges, rush a metal file approximately within the edges of the longboard.•Last but not the least, you need to use the screwdriver to push holes from the grip tape where the trucks are located.